Zoom ADSL X6 Betriebsanweisung PDF herunterladen (Seite 11)

Chapter 1: Installation Instructions 11

Plug the power cube into a power strip or wall outlet and then

plug the power cube’s other end into the modem’s power

(PWR) jack.

Important!

Only use the power cube shipped with the

. Other power

cubes may damage your hardware.

After you plug in the power cube, the PWR and WLAN lights

on the front panel of the modem should become steady on,

and the LINK light should blink. If the PWR light does not

turn on, make sure there is power at the wall outlet or power

strip where you plugged in the power cube.

Turn the computer on.

Plug one end of the supplied phone cord into the modem’s

ADSL port and the other into the ADSL wall jack. The

blinking LINK light should become steady on. If it does not,

refer to Troubleshooting on page 106.

Tip!

If your

came with an ADSL splitter, you can plug it into the

ADSL wall jack. This enables you to use the wall jack for both

your ADSL connection and for your telephone service. The

splitter has two jacks, one labeled for your ADSL modem

connection and the other for your phone.

We recommend that you install a filter on every phone

and fax machine that is sharing the ADSL phone line.

Otherwise these devices won’t work properly when they’re off-

hook and will interfere with your ADSL connection. Do not,

however, plug a filter between the wall jack and the X6.

You may have received ADSL phone filters with your

. If

you did not, or if you need more filters, they are available at

most retail stores that carry consumer electronics.

For each filter, plug the phone or fax machine’s cord into the

filter’s PHONE end and plug the filter’s LINE end into the

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 118 119

Keine Kommentare

Zoom ADSL X6 Betriebsanweisung Seite 11